High-capacity crushing of branches, slabs and wood waste to controlled finished size.
Material enters the crushing chamber through the infeed, where a high-speed rotor with hammers strikes it apart. Fractions fine enough pass through the screen and discharge while oversize keeps circulating until it passes. Swapping screens takes minutes, so one machine covers 3–8 mm finished sizes for different downstream processes.
Where this machine fits in a production line:
Don't shop by catalogue capacity alone — confirm these three things first:
Branches and offcuts go straight in; large logs should be chipped first. Match the machine to your largest regular infeed.
3–8 mm screens are typical for pellet feedstock; changing a screen takes minutes — configure for your downstream process.
Wet material crushes far slower; air-dry rainy-season feed or blend it with dry material.
The questions buyers ask most before choosing a model.
It depends on the infeed opening and rotor. Branches, bark and offcuts go straight in; larger logs should be chipped first. Tell us your maximum incoming size and we will match the machine.
Yes — the screen aperture decides it. Screens of 3–8 mm are typical for pellet feedstock; switching screens takes minutes.
Material type, moisture and feeding method matter most. The same machine can perform very differently on dry sawdust versus wet branches. We rate capacity by your worst-case material.
Blades can be resharpened and flipped several times; clean material wears them slowly, sandy or dirty material wears them fast. Regular inspection per the manual is the right habit.
Real feedback from project sites and follow-up visits.
“The whole line has been running normally in the plant — you can see the output stability with your own eyes.”
“They ran a trial with our material before recommending a model — and talked us out of the wrong one. That earned our trust.”
“Installation to first discharge in three days, with their engineer on site for commissioning.”
Prepare the following before we talk — we can identify the machine and process combination much faster.
Talk to Penghe Machinery directly about your project.
+86 137 8366 8119 ↗Company address & full contact →Tell us your raw material, target capacity and site conditions, and we will discuss a suitable configuration. Final parameters are confirmed in the technical proposal agreed by both parties.
